Cortex VEXnet Manual de instrucciones descargar pdf (Pagina 64)

ROBOTC

Download ROBOTC User Firmware • 1

2007 Carnegie Mellon Robotics Academy / For use with VEX Robotics Systems

Download ROBOTC User Firmware

You will need:

• Your VEX Microcontroller

• A computer with

ROBOTC for IFI

2.0 or later installed

• A VEX Programming Kit (1 USB-to-Serial cable, 1 VEX Robot Interface (“telephone”) Cable,

1 VEX Programming Module)

In this lesson, you will learn how to connect your VEX Microcontroller to the PC and load

the ROBOTC User rmware onto it, allowing the robot to run ROBOTC programs.

1. Plug the Robot Interface (“telephone”) Cable and the USB-to-Serial cable into the

Programming Module.

1b. ConnectRobotInterfaceCable

toProgrammingModule

Plug the end of the RJ25 “telephone”

cable into the matching port on the

Programming Module.

1a. ConnectUSB-to-SerialCable

toProgrammingModule

Plug the 9-pin Serial end of

the USB-to-Serial Cable into

the matching port on the

Programming Module.

Setup

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 94 95

Sin comentarios

Cortex VEXnet Manual de instrucciones Pagina 64