Cortex VEXnet Manual de instrucciones descargar pdf (Pagina 58)

ROBOTC

VEX Cortex Conguration over USB • 11

2011 Carnegie Mellon Robotics Academy / For use with VEX Robotics Systems

5. Press the 8U button to save the new calibration.

5. Save

Press the 8U button to save the joystick calibration

on your remote control. The JOYSTICK LED will

blink green for a few seconds.

• If the calibration is not saved, the process will timeout after 10 seconds and

the VEXnet LED will blink red.

• To cancel a calibration, press the 7U button. The calibration process will be

discontinued and the VEXnet LED will blink red.

• Once the calibration is discontinued or saved, all of the remote control LEDs

will resume their normal function.

• The joysticks must be calibrated any time the rmware on the remote control

is downloaded.

Additional Information

VEXnet Joystick Conguration in ROBOTC (cont.)

End of Section: Calibrating the VEXnet Joystick Values

The joysticks on your VEXnet Joystick are now properly calibrated and ready to be used to remote

control your robot. If you had any issues during the process, troubleshooting tips can be found on

the following page.

Setup

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 94 95

Sin comentarios

Cortex VEXnet Manual de instrucciones Pagina 58